The adsorption of model aromatic compounds (phenol, aniline, nitrobenzene) on modified activated carbons has been investigated. Electrostatic and dispersive adsorbate/adsorbent interactions are involved in this process. Their influence on the uptake of the above mentioned aromatic compounds has been evaluated using different solution pH conditions and activated carbon samples with different surface chemistries. These samples were obtained by modification of a commercial activated carbon by means of chemical treatment with HNO3 (acid sample) and thermal treatment under a flow of H-2 (basic sample). The textural properties were not significantly changed after these modifications. The best uptake for all the adsorptives under most of the pH conditions used corresponded to the basic sample, which means that dispersive interactions are the most important in this process. However, electrostatic interactions cannot be neglected, as can be seen from the uptakes for the same sample at different pH. In the case of aniline at pH 2, electrostatic interactions are predominant, and the best uptake corresponds to the acid sample. The influence of textural properties on the adsorption process was also investigated, by comparing with another commercial activated carbon. As expected, for this type of organic compounds the uptake increases with the micropore surface area. (c) 2005 Elsevier Inc. All rights reserved.