The effect of ZnO film depositions using various film deposition methods such as magnetron sputtering (MSP), pulsed laser deposition (PLD) and vacuum arc plasma evaporation (VAPE) on the photovoltaic properties of ZnO-CU2O heterojunction solar cells is described in this report. In addition, the relationship between the resulting photovoltaic properties and the film deposition conditions such as supply power and substrate arrangement was investigated in Al-doped ZnO (AZO)-CU2O heterojunction devices fabricated using AZO thin films prepared by d.c. magnetron sputtering (d.c.MSP) or r.f. magnetron sputtering (r.f. MSP). The results showed that the measured photovoltaic properties of devices fabricated with films deposited on substrates oriented perpendicular to the target were better than those of devices fabricated with films deposited on substrates oriented parallel to the target. It was also found that ZnO film depositions under conditions where a relatively weaker oxidizing atmosphere was used yield better properties than films derived from MSP, which utilizes a high-density and high-energy plasma. Using VAPE and PLD, for example, high efficiencies of 1.52 and 1.42%, respectively, were obtained under AM2 solar illumination in devices fabricated at a substrate temperature around 200 degrees C. (c) 2005 Elsevier B.V. All rights reserved.