The prospect of obtaining good adhesion of diamond films onto steel substrates is highly exciting because the achievement of this objective will open up applications in the cutting and drilling industry. However, a major problem with depositing diamond onto steel is high diffusion of carbon into steel at chemical vapour deposition (CVD) temperatures leading to very low nucleation density and cementite (Fe3C) formation. Therefore, the study of the nucleation and growth processes is timely and will yield data that can be utilised to get a better understanding of how adhesion can be improved. This work focuses on investigating the adhesion of thin diamond films on high speed steel previously coated with various interlayers such as ZrN, ZrC, TiC and TiC/Ti(C,N)/TiN. The role of seeding on nucleation density and the effect of diamond film thickness on stress development and adhesion has been investigated using SEM, XRD and Raman spectroscopy. The main emphasis in this study is the TiC interlayer which for the first time proved to be a suitable layer for diamond CVD on high speed steel (HSS). In contrast from other interlayer materials investigated here, no delamination was observed even after 3 h of CVD at 650 degrees C only when TiC was employed. Nevertheless, the increase of diamond film thickness on TiC coated HSS substrates led to the delamination of small areas in various regions of the substrate. This occurrence suggests that there was a distribution of adhesive toughness values at the diamond/TiC interface with stress development being dependent on film thickness. (c) 2005 Elsevier B.V. All rights reserved.