Effects of sorbitol concentration on the deposition of tin on to platinum were studied by cyclic voltammetry. It was observed that sorbitol affected the tin-plating rate and also the thermodynamics of the deposition process. Rotating disk electrode studies showed that the deposition rate is controlled by mass transport and that the diffusion coefficient of the Sn(II) complex decreases with increasing sorbitol concentration. The presence of sorbitol in the plating bath was beneficial since a plating current efficiency of similar to 70% was obtained, while in its absence it was similar to 19%. Scanning electron microscopy showed that sorbitol works as a brightener since tin crystallites were much smaller than those obtained from alkaline solution in the absence of sorbitol. Also, at 1.0 M, sorbitol produced a very smooth film. X-ray spectra showed that beta-Sn was deposited.