A tube-type solar still is proposed to integrate a conventional still and a water distribution network suitable to our concept of desert plantation. This still is directly set up on ground-like pipelines connecting brackish water or seawater ponds. The distilled water is immediately supplied to the plants under the ground by penetration without any extra water pipelines. The still is made of metal-free materials, e.g., plastic as vinyl chloride or PET resin which are inhibited from corrosion by seawater. Experimental data measured in our laboratory using infrared lamps showed the effectiveness of the method for productivity, the design of the basin tray and thermal efficiency up to 12.5%. Numerical simulations with experimental data as the temperature profiles at the tube walls estimated heat convection occurring within the still for modification of the Dunkle's model. Active convection over the basin was predicted in the half-cut tube type of the basin as compared with a conventional flat basin. The secondary convective circulations under the basin in case of the flat basin promote bulk flow from the upper part of the basin to the lower part, which suggests the necessity of insulating the lower part of the still. On the other hand, the tube basin enlarges the evaporative area over the basin and restricts the vapor circulation under the basin. Simulated results show that the performance of this type is not necessary for the insulation of a still and possible for setting up the lower part of the still under the ground. The tube-type solar still is very simple and has been researched, but further research is needed to make it a suitable technology:for desert plantations.