The effects of thermal treatments on the rehydration process and photocatalytic activity were investigated by H-1 NMR spectroscopy for six anatase abundant TiO2 photocatalysts with different properties. Acetic acid and benzoic acid were employed for photodecomposition in aqueous suspension. After the calcinations at 973 K, physisorbed water layers recovered relatively fast for P25, F4, and AMT-600 (shorter than 24 h) with no significant enhancement of the photocatalytic decomposition. On the other hand, for ST-01, UV-100, and AMT-100, the recovery was very slow (longer than 1 week) and only partially reversible, and the photocatalytic decomposition was considerably enhanced but retarded with rehydration. In the presence of adsorbed water, the binding of a carboxyl group of the molecules with adsorbed water is considered to compete with the direct adsorption on the surface, which reduces the amount of the direct adsorption and results in the reduction in the photocatalytic efficiency. In addition, the photocatalytic decomposition of benzoic acid with an aromatic ring was much faster in all of the TiO2 aqueous suspensions and more enhanced for the fully dehydroxylated TiO2 than that of acetic acid. These results suggest that the most efficient photocatalytic sites should be the hydrophobic sites on the TiO2 surface. The difference among the rehydration rates of different TiO2 is discussed in terms of thermally induced changes of surface morphology.