In our previous study (Wang, Y. Q.; Yang, C.-M.; Zibrowius, B.; Spliethoff, B.; Linden, M.; Schuth, F. Chem. Mater. 2003, 15, 5029), mesoporous vinyl-functionalized silica (vinyl silica) with hexagonal P6mm and cubic Ia3d structures has been synthesized at different loadings of vinyl groups and at different concentrations of sodium chloride when triblock copolymer P123 was used as a template. Our further investigations presented in this article reveal that at a loading of 10% vinyl groups, well-ordered cubic Ia3d structure was obtained at a low concentration of Na2SO4 (0.5 M) and the hexagonal structure was produced at 1.0 M NaCl. When NaNO3 was used as the inorganic salt, the hexagonal structure was still maintained even at a salt concentration of 2.0 M. The result is in accordance with the Hofmeister series order ( salting-out effect): SO42- > Cl- > NO3-. The lowering of the acidity also induced the formation of the cubic Ia3d structure. At 20% loading, hexagonal structure can be obtained by adding the more hydrophilic Pluronic F127 (EO106PO70EO106) to the acidic solutions of P123, but the hexagonal structure cannot be produced with pure P123 under the synthesis conditions investigated. All of these results can be rationalized through hydrophilic-hydrophobic balance and the change in micellar curvature. Furthermore, 10% mercaptopropyl-functionalized mesoporous silica with cubic Ia3d structure was designed and synthesized successfully with the assistance of an inorganic salt ( NaCl) in an acidic solution of P123, which is the first example of mercaptopropyl-functionalized large-pore mesoporous silica with high loadings.