In associative charge transfer (ACT) reactions, a core ion activates ligand molecules by partial charge transfer. The activated ligand polymerizes, and the product oligomer takes up the full charge from the core ion. In the present system, benzene(+.) (Bz(+.)) reacts with two propene (Pr) molecules to form a covalently bonded ion, C6H6+. + 2 C3H6 -> C6H12+. + C6H6. The ACT reaction is activated by a partial charge transfer from Bz(+.) to Pr in the complex, and driven to completion by the formation of a covalent bond in the polymerized product. An alternative channel forms a stable association product (Bz, Pr)(+.), with an ACT/association product ratio of 60:40% that is independent of pressure and temperature. In contrast to the Bz(+.)/propene system, ACT polymerization is not observed in the Bz(+.)/ethylene (Et) system since charge transfer in the Bz(+.)(Et) complex is inefficient to activate the reaction. The roles of charge transfer in these complexes are verified by ab initio calculations. The overall reaction of Bz(+.) with Pr follows second-order kinetics with a rate constant of k (304 K) = 2.1 x 10(-12) cm(3) s(-1) and a negative temperature coefficient of k = aT(-5.9) (or an activation energy of -3 kcal/mol). The kinetic behavior is similar to sterically hindered reactions and suggests a [ Bz(+.) (Pr)]* activated complex that proceeds to products through a low-entropy transition state. The temperature dependence shows that ACT reactions can reach a unit collision efficiency below 100 K, suggesting that ACT can initiate polymerization in cold astrochemical environments.