Experiments were performed with two model soot aerosols brought into different forms of contact with Pt aerosol particles, to investigate the effectiveness of this contact in lowering the catalytic soot oxidation temperature. The contact was either generated between individual particles in the aerosol state (Pt-doped soot to simulate a fuel borne catalyst), or by sequential or simultaneous deposition of separately generated soot and Pt aerosols onto a sintered metal filter. (Formation of a soot cake on previously deposited Pt aerosol would simulate a catalyst coated diesel particle filter.) The catalytic activity was determined in all cases from temperature ramped oxidation in air of the filtered particles, and defined as the 50% conversion temperature. It was found that Pt-doped soot and simultaneously filtered aerosols were both equally effective in reducing the oxidation temperature by up to 140-250 degrees C for the spark discharge soot (with 3-47 wt% Pt concentration in the soot cake), and by up to 140 degrees C for the pyrolysis soot (3 wt% Pt). Conversely, the deposition of a thin soot layer of 5-10 mu m thickness onto Pt, or vice versa, produced only a slight temperature reduction on the order of about 13-42 degrees C. These results suggest that the distance between soot and Pt particles plays a key role in promoting an effective oxidation on the filter, which is consistent with the role of Pt particles as local generators of activated oxygen. (C) 2006 Elsevier B.V. All rights reserved.