This work is an extension of previous studies [S. Masiuk, Power consumption measurement in a liquid vessel that is mixed using vibratory agitator, Chem. Eng. J. 75 (1999) 161-165; S. Masiuk, Mixing time for a reciprocating perforated plate agitator, Inz. Chem. Proc. 20 (1999) 601-612; S. Masiuk, Dissolution of solid body in a tubular reactor with reciprocating plate agitator, Chem. Eng. J. 83 (2001) 139-144; S. Masiuk, Heat transfer measurement in a liquid vessel that is mixed using vibratory agitator, Chem. Eng. J. 61 (1996) 107-112] carried out on the reciprocating agitator, in which additional information describing the experimental apparatus and measurements procedure may be found, as well as, dimensionless correlations predicted for agitator with a single plate. The experimental investigation are provided for the explanation of the influence on the power consumption, mixing time, mass and heat transfer of the multiplates low-frequency and high amplitude reciprocating agitators. The maximum power consumption is calculated by multiplying the maximum force acting on the shaft and maximum velocity of the agitator. A thermal-response technique is used for mixing time measurements. The mass transfer coefficient is calculated from a mass balance between a dissolution solid body and its surrounding mixing dilute solution. The heat transfer coefficient from the heating jacket wall to the continuous flow of the mixed liquids is measured by the stabilized heat flow method. The analytical dimensionless equations predicted in the present paper generalize the experimental data without the break through the all regions of flow in a relatively simple and uniform manner. (c) 2006 Elsevier B.V. All rights reserved.