Crosslinked linear low density polyethylene (XLPE) containing polyolefin elastomers (POE) has been evaluated. The blends with different dicumyl peroxide (DCP) and POE contents have been prepared and processed by compression molding. A series of the samples obtained have been investigated by gel content determination, scanning electron microscopy (SEM), different scanning calorimetry (DSC), mechanical, and dielectric behaviors measurements. The results obtained clearly show the relevant influence of the POE content, as well as of the DCP content, which tends to enhance crosslinking. As expected, the toughness of XLPE is improved by using adequate content of POE, and the blends exhibit a much more similar tensile behavior to that of elastomer. In addition, the results indicate that the blends possess the excellent dielectric behaviors, such as dielectric constant and dissipation factor. The crystallinity of the blends decreases as the DCP and POE contents increase. The melting temperature of the blends also decreases with the increase of DCP content, while POE content has few influences on the melting temperature of the blends. The SEM images strongly reveal that the blends are partially compatible, and the POE can be dispersed well in the matrix. (c) 2007 Wiley Periodicals, Inc.