Isobutene oligomerization was carried out at room temperature over sulfated-titania sol-gel catalysts prepared by three methods; (i) "in situ" sulfation using sulfuric acid. (ii) gelling with nitric acid and sulfation (a), and (iii) gelling with ammonium hydroxide and sulfation (b). XRD spectra identified anatase as the crystalline phase in all the sulfated samples. The specific surface areas were 126, 115 and 62 m(2)/g. and FTIR-pyridine total acidity was 280, 105 and 160 mmol/g, showing L/B ratios of 3.65, 1.82 and 1.25, for the "in situ", sulfated (a) and sulfated (b) samples, respectively. For the isobutene oligomerization carried out in a continuous flow reactor, the "in situ" sample showed 100% of conversion even after 90 h in stream, with selectivity to C-8-C-12 olefins of 76%. In TiO2 sulfated (a) the initial conversion was 100%, and it was maintaining during 40 h with selectivity to C-8-C-12 olefins of 88%. On the other hand, TiO2 sulfated (b) sample showed a continuous and pronounced lost in activity. In this case the selectivity to C-8 olefins, it evolves with time and reaches values of 70%. It has been proposed that the catalytic behavior of the sulfated TiO2 catalysts strongly depends on the relative Lewis/Bronsted sites abundance. At higher L/B ratio corresponds higher catalyst stability. (C) 2004 Elsevier B.V. All rights reserved.