Herein reported are investigations of norbornene polymerization by novel anilido-imino nickel complexes [((ArN)-N-1=CHC6H4NAr2)NiBr](2) (Ar-1 = Ar-2 = 2,6-dimethylphenyl, 1; Ar-1 = 2,6-dimethylphenyl. Ar-2 = 2,6-diisopropylphenyl, 2. Ar-1 = Ar-2 = 2,6-diisopropylphenyl. 3. Ar-1 = 2.6-diisopropylphenyl, Ar-2 = 2.6-dimethylphenyl, 4) activated with methylaluminoxane (MAO). It was found that at polymerization temperatures below 50 degrees C, the average molecular weights of the obtained polynorbornenes catalyzed by these four catalytic systems increase with raising temperature, displaying bimodal distribution in GPC curves. The abnormal influence of polymerization temperature could be attributed to the existence of two kinds of catalytic species: heterobimetallic species LNi(II)(mu-Me)(2)AIMe(2) (I) and monometallic species LNi(II)Me (II) (L = anilido-imino ligand) at lower temperature. The former affords a lower molecular weight polymer and the latter higher molecular weight one. With raising polymerization temperature above 50 C, the species I disappears and only species 11 exists in polymerization systems, resulting in a normal relation of molecular weight to polymerization temperature, Front a kinetic study of the norbornene polymerization catalyzed by 1/MAO catalyst at 70 degrees C, the polymerization rate (R-p) can be expressed by the formulation: R-p = k[NBE](103)[Ni](088). Moreover, the mechanism of the norbornene polymerization using the anilido-imino nickel complexes activated with MAO is also presented and discussed. (c) 2005 Elsevier B.V. All rights reserved.