Nickel oxide (NiO) was screen printed onto the surfaces of 3 and 8 mol% yttria-stabilized zirconia (YSZ) dense pre-fired substrates and then heat treated at temperatures from 1350 degrees to 1550 degrees C. The effect of NiO was dependent on the yttria content of the substrate. In 3 mol% YSZ, it was found to alter the phase composition from predominantly tetragonal with a small amount of cubic phase to one consisting of approximately equal amounts of cubic and monoclinic phase. The cubic grains were much larger than the monoclinic ones and contained more nickel. Furthermore, nickel was observed to migrate through the thickness of the tile, a distance of approximately 200 mu m. In the 8 mol% YSZ substrates, the phase composition was unaltered, although large grains developed under the printed NiO layer and the nickel migration was confined to the extent of these large grains.