This paper examines the capabilities of cryogenic sample handling to examine composition and structure of hydrogel materials where siloxane components are central to the analysis. XPS analysis of multicomponent polymers with cryogenic sample handling following exposure to aqueous environments has revealed the composition and kinetics of near surface reorganization for siloxane and fluorocarbon containing polymers. In this study we report results from a ToF-SIMS protocol for cryogenic sample handling applied to the analysis of surface changes upon hydration/dehydration of hydrogel polymers. Comparison of results from angle dependent XPS and ToF-SIMS are discussed for a range of commercial soft contact lens materials. Both methods detected changes in surface chemistry between the hydrated (frozen) and dehydrated surfaces. Analysis of the hydrated surfaces detected polymer components indicative of the commercial formulation as well as ice clusters. Analysis of the dehydrated materials detected changes in surface chemistry relative to the hydrated surface in addition to loss of water due to sample dehydration. A quantitative standard additions method for ToF-SIMS data was used to determine submonolayer amounts of PDMS impurities at the surface of the hydrogels. ToF-SIMS analysis of a series of seven poly (allyl methacrylate-g-dimethylsiloxane), AMA-g-DMS, graft copolymers in the hydrated state revealed high mass oligomeric ion distributions for systems with bulk PDMS content greater than 25 wt.%. This marks the first time that detection of high mass oligomeric ion distributions from hydrated (frozen) surfaces has been reported. Analysis of the dehydrated surface detected formation of high mass oligomeric ion distributions for systems with PDMS bulk content greater than 15 wt.%, but only detected these ion distributions in wet (frozen) samples when the bulk concentration was greater than 25 wt.%. (c) 2006 Elsevier B.V. All rights reserved.