A possible approach in describing the role of the environment in the phenomena behind initiation and propagation of a stress corrosion crack is to assume that the transport of matter and charge through the oxide film on the material is one of the rate-controlling factors. Straining of the bulk material may affect the transport rates of ionic defects, such as vacancies and interstitials, through the oxide film. The aim of the present work has been to verify the applicability of combined slow strain rate tests (SSRT) and contact electric resistance (CER) measurements to assess the influence of strain on the electric properties of oxide films on AISI 316L stainless steel with or without prior cold work in simulated boiling water reactor (BWR) coolant conditions. The SSRT-CER measurements have been combined with ex situ characterisation of the oxide films after experiments using electron spectroscopy for chemical analysis (ESCA) and scanning electron microscopy (SEM). The results suggest that the effect of strain on the resistance of the oxide films seems to correlate with the effect of the same parameter on the Cr(III) concentration in the inner layer of the oxide. In addition, important differences between the concentration of Ni and Fe in the outer layer formed on stressed and unstressed surface have been observed. Based on the mixed-conduction model for oxide films, an attempt is made to evaluate the effect of straining on the electric properties of the oxide films and to correlate these effects with the changes in film composition and structure. (c) 2005 Elsevier B.V. All rights reserved.