화학공학소재연구정보센터
Composite Interfaces, Vol.13, No.4-6, 523-534, 2006
Preparation of poly(vinyl alcohol)-silicone based hybrid membranes for the pervaporation separation of water-acetic acid mixtures
Hybrid membranes were prepared using poly(vinyl alcohol) (PVA) and tetraethylorthosilicate (TEOS) via hydrolysis followed by condensation. The obtained membranes were characterized by Fourier transform infrared spectroscopy, wide-angle x-ray diffraction and differential scanning calorimetry. A remarkable decrease in degree of swelling was observed with increasing TEOS content in membranes and is attributed to the formation of hydrogen bonding and covalent bonds in the membrane matrix. The pervaporation performance of these membranes for the separation of wateracetic acid mixtures was investigated in terms of feed concentration and the content of TEOS used as cross-linking agent. The membrane containing 1:2 mass ratio of PVA and TEOS gave the highest separation selectivity of 1116 with a flux of 3.33 x 10(-2) kg/m(2) h at 30 degrees C for 10 mass% of water in the feed. Except for membrane M-1, the observed values of water flux are close to the values of total flux in the investigated composition range, signifying that the developed membranes are highly water selective. From the temperature dependence of diffusion and permeation values, the Arrhenius apparent activation parameters have been estimated. The resulting activation energy values obtained, showing that water permeation is lower than that of acetic acid, suggest that the membranes have higher separation efficiency. The activation energy values calculated for total permeation and water permeation are close to each other for all the membranes except membrane M-1, signifying that coupled-transport is minimal because of the higher selective nature of membranes. The negative heat of sorption values (Delta Hs) for water in all the membranes suggests a Langmuir mode of sorption.