Electrochimica Acta, Vol.52, No.22, 6304-6309, 2007
Electrochemical generation of hydrogen peroxide using surface area-enhanced Ti-mesh electrodes
Ti-mesh electrodes coated with Ti were obtained by using an electrophoretic deposition (EPD) method. The Ti coating was porous and showed a good adherence to the Ti-mesh surface, due to sintering of Ti particles during thermal treatment at 900 degrees C. The Ti-coated mesh electrode has a BET surface area of 3.5 m(2)/g, about four times larger than that of the bare electrode. The surface area-enhanced Ti-mesh electrode was applied in electrical generation of hydrogen peroxide. It was shown that the rate of hydrogen peroxide generation increased drastically compared to the fresh electrode, since the larger electrode surface area enhanced not only current density, but also the oxygen mass transfer rate. (c) 2007 Published by Elsevier Ltd.