New Pt(ll) dichloride complexes [Pt(l -iqdzH)C121 (2a) and [Pt(3-iqdzH)CI21 (2b), in which idqzH = 1 - or 3-isoquinolinyl indazole, were prepared by treatment of the corresponding indazoles with K2PtCl4 in aqueous HC1 solution. Despite their nonernissive nature, these complexes could react with excess indazole, sodium picolinate, and 3-trif I uoro m ethyl5-(2-pyridyl) pyrazole [(fppz)H] to afford the respective a and b series of luminescent complexes [Pt(l-iqdz)(L AX)j and [Pt(3-iqdz)(L AX)], where LIX = 1-iqdz (1a), 3-iqdz (1b), pic (3a, 3b), and fppz (4a, 4b). Single-crystal X-ray diffraction studies of 1b, 2a, and 3b revealed a planar molecular geometry without notable intermolecular Pt... Pt contact in the solid crystal, a result of the steric repulsion imposed by the bulky indazole fragments. For coordination complexes 1, 3, and 4, photoluminescence in degassed CH202 revealed high quantum efficiency and short radiative lifetimes in the range of several microseconds. As supported by the spectral feature, the associated radiation lifetimes, and a computational approach based on time-dependent density function theory (TD-DFT), the origin of the emission is attributed to a mixed 3 MLCT/3g,-r transition. The TD-DFT approach further confirmed that, except for the series 1 complexes, the HOMO of 3-iqdz complexes 3b and 4b is much less located at the central Pt(1l) atom than the HOMO orbitals of the respective 1-iqdz complexes 3a and 4a, leading to a smaller degree of MLCT contribution. Consequently, there are a blue-shifted emission signal and an inferior emission quantum yield for the 3-iqdz derivatives. OLED devices with a multilayer configuration of 1TO/NPB/CBP:3a/BCP/Alq LiF/Al were fabricated using a CBP layer doped with various concentrations of 3a, ranging from 6% to 100%, within the emitting layer. The best device performance was realized using a 6% doping concentration, for which the external quantum yield of 4.93%, luminous efficiency of 12.19 cd/A, and power efficiency of 6.12 Im W-1 were observed at 20 mA/cm', while a maximum luminescence as high as 20296 cd/M2 was also realized at 16 V, showing good prospect for the fabrication of Pt(ll) based OLEDs.