The power law-creep behavior of superplastic Sn-40Pb-2.5Sb alloys with different grain sizes has been investigated at room temperature. Stress exponent values for these alloys have been determined by indentation creep, conventional creep and uniaxial tension tests in order to evaluate the correspondence of indentation creep results with conventional tests. In all cases, the indentation results were in good agreement with each other and with those of the tensile and conventional creep tests. The average stress exponent values of about 2.6 and 3.0 corresponding to the strain rate sensitivity (SRS) indices of 0.33-0.39, depending on the grain size of the materials, indicate that the grain boundary sliding is the possible mechanism during creep deformation of Sn-Pb-Sb alloys. Within limits, the indentation tests are thus considered useful to acquire information on the creep behavior of small specimens of these soft tin-lead-antimony alloys at room temperature. It is also demonstrated that the indentation creep test provides a convenient method to measure SRS and thereby to assess the ability of a material to undergo superplastic deformation.