Membrane fouling is the major limitation for a broader application of membrane technology. One of the main causes of membrane fouling in advanced wastewater reclamation and in membrane bioreactors (MBR) are the extracellular polymeric substances (EPS). Among the main constituents in EPS, polysaccharides are the most ubiquitous. This study aims at a better understanding of the fouling mechanisms of EPS and the efficiency of backwashing technique, which is applied in practice to restore membrane flux. For that purpose, the evolution of fouling by sodium alginate, a microbial polysaccharide, is studied in ultrafiltration. Fouling experiments are carried out in a single fiber apparatus, aiming at identifying the significance of distinct fouling mechanisms and their degree of reversibility by backwashing. An important parameter considered in the study is the concentration of calcium ions, which promote sodium alginate aggregation and influence the rate of flux decline, the reversibility of fouling and rejection. A rapid irreversible fouling takes place due to internal pore constriction, at the beginning of filtration, followed by cake development on the membrane surface. With increased calcium addition, cake development becomes the dominant mechanism throughout the filtration step. Furthermore, fouling reversibility is increased with the increase of calcium concentration. A unique behavior of sodium alginate solution in the absence of calcium is also noted, i.e. the formation of a labile layer on the membrane Surface, which is affected by the small cross-flow that exists inside hollow fibers, even in the nominally dead-end mode of operation. (C) 2007 Elsevier B.V. All rights reserved.