The conventional paste used to produce plates for lead-acid batteries comprises a mixture of leady oxide, water and sulfuric acid. Fibre and other additives, such as expander in negative plates, are added to improve paste properties and battery performance. Following pasting of the plates, they have to be cured to provide the correct chemical composition and crystal morphology, and to oxidize any residual free lead metal to lead monoxide. The desired result of the curing process is a positive plate with a high concentration of uniformly sized tetrabasic lead sulfate (4BS) crystals and with both positive and negative plates having a low concentration of free lead. Curing is a time-consuming and expensive process, which requires large numbers of chambers capable of being heated to 85 degrees C and containing an atmosphere with a relative humidity greater than 95%. This process adds significant cost to the battery. (C) 2006 Elsevier B.V. All rights reserved.