The effect of the molecular structure of styrene-butadiene (SB) block copolymers and ethene-propene (EPM) random copolymers on the morphology and tensile impact strength of low-density polyethylene (LDPE)/polystyrene (PS) (75/25) blends has been studied. The molecular characteristics of SB block copolymers markedly influence their distribution in LDPE/PS blends. In all cases, an SB copolymer is present not only at the interface but also in the bulk phases; this depends on its molecular structure. In blends compatibilized with diblock copolymers, compartmentalized PS particles can also be observed. The highest toughness values have been achieved for blends compatibilized with triblock SB copolymers. A study of the compatibilization efficiency of SB copolymers with the same number of blocks has shown that copolymers with shorter PS blocks are more efficient. A comparison of the obtained results with previous results indicates that the compatibitization efficiency of a copolymer strongly depends both on the blend composition and on the properties of the components. The compatibilization efficiency of an EPM/SB mixture is markedly affected by the rheological properties of the copolymers. The addition of an EPM/SB mixture containing EPM with a higher viscosity leads to a higher improvement or at least the same improvement in the tensile impact strength of a compatibilized blend as the same amount of neat SB. (C) 2007 Wiley Periodicals, Inc.