During continuous peeling, a central polymer rod free of visible defects was continuously extruded while being peeled at the die exit. Continuous peeling can occur at flow rates orders of magnitude higher than those at which initial surface cracking is observed. Thus, if continuous peeling can be controlled it may have potential industrial applications. The aim of this work was to study how different extrusion parameters (temperature, flow rate, die length and diameter) affect the presence of continuous peeling. The melt exiting the die has been filmed to link physical measurements and observations and to determine whether or not continuous peeling is present. Different criteria have been considered to represent the extrusion conditions under which continuous peeling may occur. Surface tension criteria can be used to try to predict the appearance and disappearance of continuous peeling. A correlation formula is also proposed for the rod diameter in terms of surface tension. Our results show that the ratio of the rod diameter to the die diameter is approximately 25% greater in the case of short-orifice dies (LID approximate to 0) than for long capillaries (LID approximate to 10). The correlations obtained allow analysis and discussion of flow regimes for possible applications. (c) 2007 Elsevier B.V. All rights reserved.