This article reports on the properties of ultraviolet nanoimprint lithography dedicated imprinting materials. Studied solutions are composed of a diacrylate-based monomer and a variable amount (1%, 2%, and 4% in weight) of three different photoinitiators from Ciba Specialty Chemicals (Irgacure 819, Irgacure OXE02, and Irgacure 379). Photopolymerization kinetic studies were conducted on these solutions. Quantity and type of photoinitiator could be optimized in order to obtain a polymerization rate higher than 95% with an exposure dose as low as 20 mJ/cm(2). The etch resistance of this home-developed imprinting resist was characterized under standard plasma etching conditions. We observed that the polymerization rate has a large influence on the plasma etch resistance, and we show that the etch rates of our best material is comparable to the one measured for 193 nm photolithography resists and makes it a very good candidate as a masking layer for direct pattern transfer. (c) 2007 American Vacuum Society.