Corrosion of steel under the defected coating in near-neutral pH solution was investigated by localized electrochemical impedance spectroscopy (LEIS) measurements. The LEIS response is dependent on the size of the defect. For small defects, e.g., less than 200 mu m in diameter, localized corrosion process and mechanism of steel, as indicated by the measured LEIS plots, change with time. The diffusion process dominates the interfacial corrosion reaction, which is due to the block effect of the deposited corrosion product combined with the geometrical factor of a large coating thickness/defect width ratio. In the presence of a big defect, e.g., up to 1000 mu m, the LEIS responses measured at the defect are always featured by a coating impedance in the high-frequency range and an interfacial corrosion reaction in the low-frequency range. The block effect of corrosion product does not apply due to the relatively open geometry. Conventional EIS measurements on a macroscopic-coated electrode reflect the "averaged" impedance results from both coating and defect. The information of the localized electrochemical corrosion processes and mechanisms at the small defect is lost, and the coating impedance information is "averaged" out when a big defect is contained. LEIS measurement provides an essential technique to characterize microscopically the local electrochemical corrosion reaction of steel under the defected coating. (C) 2008 Elsevier Ltd. All rights reserved.