This paper presents the thermal and economic analysis of a mobile wood chip drying process. The dryer was subjected to different operating conditions, which were studied in order to determine the optimal characteristics of the dryer in terms of energy consumption. In addition, the impact of the exterior climatic conditions on the dryer's performance was also evaluated. The performance of the dryer coupled with an absorption heat pump was modeled in steady-state conditions under different operating parameters. Finally the system's energy performance was compared to the performance of two other systems (a wood burning furnace and a waste-heat recovery system). The results demonstrate that single-stage absorption heat pumps are only interesting when the set point temperature of the drying air is below 60 degrees C. Otherwise, a two-stage absorption heat pump must be used. In terms of energy and financially, this type of drying is very costly. Of the three processes that were studied, heat recovery systems proved to be the most energy efficient and economic solution. (C) 2007 Elsevier Ltd. All rights reserved.