Small and large amplitude oscillatory shear measurements (SAOS and LAOS) were used to investigate the rheological behavior of short glass fibers suspended in polybutene and molten polypropylene. Raw torque and normal force signals obtained from a strain-controlled instrument (ARES rheometer) were digitized using an analog to digital converter (ADC) card to allow more precise data analysis. The fiber concentration did not affect the torque signal in the SAOS mode, except for its magnitude, whereas the normal force signal was too low to be measurable. With increasing strain amplitude, the magnitude of the torque became a function of time. Depending oil the applied frequency and strain rate, the stress in the filled polybutene increased with time, whereas for reinforced polypropylene (viscoelastic matrix), the behavior was opposite, i.e. the stress decreased with time. These effects were more pronounced at high fiber content. In addition the primary normal stress differences were no longer negligible at large deformation amplitude and exhibited a non-sinusoidal periodic response. Fast Fourier transform (FFT) analysis was performed and the resulting spectra, along with Lissajous figures of the shear stress and the primary normal stress differences, are explained in terms of fiber orientation. The experimental results for the suspensions in polybutene are well predicted by the Folgar-Tucker-Lipscomb (FTL) model. (C) 2008 Elsevier B.V. All rights reserved.