An explanation for the superior proton conductivity of low equivalent weight (EW) short-side-chain (SSC) perfluorosulfonic acid membranes is pursued through the determination of hydrated morphology and hydronium ion diffusion coefficients using classical molecular dynamics (MD) simulations. A unique force field set for the SSC ionomer was derived from torsion profiles determined from ab initio electronic structure calculations of an oligomeric fragment consisting of two side chains. MD simulations were performed on a system consisting of a single macromolecule of the polymer (EW of 580) with the general formula F3C-[CF(OCF2CF2SO3H)-(CF2)(7)](40)-CF3 at hydration, levels corresponding to 3, 6, and 13 water molecules per sulfonic acid group. Examination of the hydrated morphology indicates the formation of hydrogen bond "bridges" between distant sulfonate groups without significant bending of the polytetrafluoroethylene backbone. Pair correlation functions of the system identify the presence of ion cages consisting of hydronium ions hydrogen-bonded to three sulfonate groups at the lowest water content. Such structures exhibit very low S-OH3+ separations, well below 4 A and severely inhibit vehicular diffusion of the protons. The number of sulfonate groups in the first solvation shell of a given hydronium ion correlates well with the differences between Nafion and the SSC polymer (Hyflon). The calculated hydronium ion diffusion coefficients of 2.84 x 10(-7), 1.36 x 10(-6), and 3.47 x 10(-6) cm(2)/s for water contents of 3, 6, and 13, respectively, show only good agreement to experimentally measured values at the lowest water content, underscoring the increasing contribution of proton shuttling or hopping at the higher hydration levels. At the highest water content, the vehicular diffusion accounts for only about 1/5 of the total proton transport similar to that observed in Nafion.