This study tentatively used an iron (Fe) and carbon (C) primary cell, instead of dc electric power, to drive the electromigration of cadmium in contaminated soils. The addition of acid to C compartment increased the electric potential, while the addition of acid to Fe compartment had a slight influence on the potential. It was feasible using the primary cell to drive the electromigration of cadmium in kaolin. The electromigration efficiencies were highly related to the soil pH. Lower pH led to greater migration efficiency. The mechanisms involved the desorption of cadmium from soils to pore solution and the electromigration of cadmium in the pore solution. The desorption was critical to the electromigration process. The series of primary cells could expand the treatment area, but the electromigration efficiencies of cadmium in each cell were less than that achieved by single primary cell. Since the potential gradient produced by the primary cell was rather low, the electromigration rate of pollutants was very low and remediation duration was long. The application would be acceptable in some specific sites, such as acidic soils or artificially controlled acid conditions so that heavy metals have been desorbed from soils. (C) 2007 Elsevier B.V. All rights reserved.