Applied Surface Science, Vol.255, No.5, 2951-2957, 2008
Low-energy hydrogen ion shower (LEHIS) treatment of polytetrafluoroethylene (PTFE) materials
The wettability and optical transmittance properties of hydrogen ion treated polytetrafluoroethylene (PTFE) materials were evaluated using contact angle, laser irradiation, scanning electron microscopy (SEM), and Fourier transform infrared spectroscopy (FTIR) tests. The materials were processed using low-energy hydrogen ion shower (LEHIS) produced by a gas discharge ion source (GDIS). The duration of treatment and ion shower energy were varied to determine their effects on the PTFE specimens. Mass spectrometry showed the ion shower constituents to be H+ and H-2(+) species. Within the bounds of the discharge conditions, flux density for the H-n(+) beam measured a minimum of 0.06 A/m(2) and a maximum of 0.25 A/m(2). Both one-and two-way analysis of variance were employed to assist in the interpretation of the empirical data. Results showed that treatment using lower plasma discharge currents (I-d) improved material hydrophobicity with contact angles measuring a high of 115 degrees while higher I-d resulted in enhanced hydrophilicity reducing contact angles down to 61 degrees. Transmittance and wettability were found to correlate, i.e., a surface made more wettable became optically transmissive allowing as much as 99% signal transmittance. Conversely, a surface made more hydrophobic reduced light leakage to as low as 60%. As the material showed increased surface striations, its optical transmittance, wettability, and surface tension also increased. With no observable shifting of the IR-absorption peaks, the surface modi. cation was essentially morphological in character. (C) 2008 Elsevier B.V. All rights reserved.
Keywords:Polytetrafluoroethylene (PTFE);Low-energy hydrogen ion shower (LEHIS);Gas discharge ion source (GDIS);Wettability;Contact angle;Optical transmission;Scanning electron microscopy (SEM);Fourier transform infrared spectroscopy (FTIR)