Applied Surface Science, Vol.255, No.12, 6297-6302, 2009
UV laser irradiation of IR laser generated particles ablated from nitrobenzyl alcohol
Particles generated by 2.94 mu m pulsed IR laser ablation of liquid 3-nitrobenzyl alcohol were irradiated with a 351 nm UV laser 3.5 mm above and parallel to the sample target. The size and concentration of the ablated particles were measured with a light scattering particle sizer. The application of the UV laser resulted in a reduction in the average particle size by one-half and an increase in the total particle concentration by a factor of nine. The optimum delay between the IR and UV lasers was between 16 and 26 mu s and was dependent on the influence of the IR laser: higher influence led to a more rapid appearance of particulate. The ejection velocity of the particle plume, as determined by the delay time corresponding to the maximum two-laser particle concentration signal, was 130 m/s at 1600 J/m(2) IR laser influence and increased to 220 m/s at 2700 J/m2. The emission of particles extended for several ms. The observations are consistent with a rapid phase change and emission of particulate, followed by an extended emission of particles ablated from the target surface. (C) 2009 Elsevier B.V. All rights reserved.