Chemical-looping combustion of biomass was carried out in a 10 kW(th) reactor with iron oxide as an oxygen carrier. A total 30 h of test was achieved with the same batch of iron oxide oxygen carrier. The effect of the fuel reactor temperature on gas composition of the fuel reactor and the air reactor, the proportion of biomass carbon reacting in the fuel reactor, and the conversion of biomass carbon to CO2 in the fuel reactor was experimentally investigated. The results showed that the CO production from biomass gasification with CO2 was more temperature dependent than the CO oxidation with iron oxide in the fuel reactor, and an increase in the fuel reactor temperature produced a higher increase for the CO production from biomass gasification than for the oxidation of CO by iron oxide. Although the conversion of biomass carbon to CO2 in the fuel reactor decreased with the increase of the fuel reactor temperature, there was a substantial increase in the proportion of biomass carbon reacting in the fuel reactor. X-ray diffraction (XRD) and scanning electron microscopy (SEM) were utilized to characterize fresh and reacted oxygen carrier particles. The results showed that the transformation of Fe2O3 to Fe3O4 is the favored step in the process of iron oxide reduction with biomass syngas. The low reactivity of reacted oxygen carrier was mainly ascribed to the sintering grains on the particle surface. To restrain the surface sintering of oxygen carrier particles, an intensive oxidization of reduced oxygen carrier with air in the air reactor should be avoided in the process of oxygen carrier regeneration, and air staging should be adopted for the oxidization of reduced oxygen carrier with air in the air reactor.