The melt fracture behaviors of linear and branched polypropylene resins with foaming additives were investigated. The effects of branching, processing temperature, additives, and blowing agent on the surface melt fracture of polypropylene materials were thoroughly studied. A CCD camera was installed at the die exit to precisely observe the onset of surface melt fracture of extruded foams. The critical wall shear stress was determined for various linear and branched polypropylene resins using a capillary die. It was found that the branching required to foam polypropylene resins also promotes melt fracture: the critical shear stress was decreased by 0.0175 MPa with an increase of 0.1 n/1000c in long-chain branching. It was also observed that the dissolved blowing agent (butane) significantly suppressed the melt fracture of both linear and branched polypropylene resins. On the other hand, a noticeable increase in the critical shear stress of branched polypropylene materials was observed with the nucleating agent (talc) and the aging modifier (glycerol mono stearate), whereas almost negligible effect of the additives on the critical shear stress was observed for linear polypropylene materials. (c) 2008 Wiley Periodicals, Inc.