Batch contact, tank leaching and column percolation tests were conducted to investigate the Cr(VI) concentration in the solution/leachate from two fly ashes (fly ash A and B) with additives. The additives used were cement, low alkalinity additive and Ariake clay. There are several factors influencing Cr(VI) concentration in solution/leachate, namely (1) properties of solid/liquid mixture (chemical composition, pH value, etc.), (2) cementation effect, (3) amount of water in contact with the solid mass (solid/liquid ratio in case of batch contact test), and (4) adsorption characteristics of the solid particles to Cr ions. The test results indicate that fly ash A has less cementation component (CaO of 1.92%) and the amount of water in contact with the fly ash played an important role. As a result, Cr(VI) concentration from the column percolation test was much higher than that of the batch contact test. Adding Ariake clay had more effect on reducing Cr(VI) concentration for fly ash A than B because the pH value of the solution from fly ash A was lower, which provided a favorable condition for Cr(VI) ions to be reduced to Cr(III) and possibly to be adsorbed by clay particles. Fly ash B has more cementation component (7.15%) and for column percolation test, curing the sample for I week reduced Cr(VI) concentration significantly. The test results indicate that in engineering practice, a method which closely simulates the field condition should be selected to assess possible environmental effects and corresponding countermeasure methods. (C) 2008 Elsevier B.V. All rights reserved.