The effect of acyl chloride chemical structure on the ethanol aqueous solution dehydration through the poly(thiol ester amide) thin-film composite membrane prepared by reacting 2-aminoethanethiol (AETH) with trimesoyl chloride (TMC) or succinyl chloride (SCC) on the surface of the modified asymmetric polyacrylonitrile (mPAN) membrane was investigated. SEM/EDX, ATR-FTIR and water contact angle were applied to analyze the S element, chemical structure, and hydrophilicity of the poly(thiol ester amide) active layer of the composite membrane. In order to estimate the variation in the free volume of the poly(thiol ester amide) active layer and correlate that with the pervaporation performance. positron annihilation spectroscopy (PAS) experiments were conducted, in which a variable monoenergy slow positron beam was used. Doppler broadening S parameters of annihilation radiation energy spectra showed a significant variation with the acyl chloride chemical structures of the poly(thiol ester amide) active layers. The S parameters of the AETH-TMC/mPAN thin-film composite membrane were found to be lower than those of the AETH-SCC/mPAN thin-film composite membrane. In the ethanol aqueous solution dehydration, the AETH-TMC/mPAN thin-film composite membrane exhibited a lower permeation rate and a higher water concentration in the permeate than the AETH-SCC/mPAN. This is in good agreement with the analysis by positron annihilation spectroscopy. The solution effect dominated the pervaporation separation behavior of the poly(thiol ester amide) thin-film composite membrane with TMC substituting for SCC in the poly(thiol ester amide) active layer. The AETH-TMC/mPAN membrane was found to exhibit superior performance compared with some membranes discussed in the literature. (c) 2008 Elsevier B.V. All rights reserved.