Polymer electrolyte membrane fuel cell performance strongly depends on properties of the fuel cell stack bipolar plates. Composite bipolar plates, though low cost and convenient in manufacturing, raise a major concern due to their high interfacial contact resistance caused by the mechanical treatment used to remove the polymer-rich layer on the Surface. It is observed that most of this contact resistance is governed by electrical properties of the interface layer between the contacting surfaces. Measurements of contact resistance of mechanically polished composite bipolar plate/gas diffusion layer interface reveal a substantial influence of surface topography on the contact resistance, which varies significantly depending on the substrate surface treatment and toughness of composite bipolar plates. (C) 2008 Elsevier B.V. All rights reserved.