In many cases, biomaterials surfaces are desired to he resistant to protein adsorption. A system fulfilling this task in nature is the so-called glycocalyx. The glycocalyx is an outer layer on the cell membrane with bound glycoproteins and glycolipids, exposing a pattern of carbohydrate groups. There is a growing interest to mimic this glycocalyx layer to have a tool to overcome the problems with uncontrolled protein adsorption on biomaterials. In this work a glycocalyx-like layer is artificially imitated by surface-initiated atom transfer radical polymerization (ATRP) of a glycomonomer, D-gluconamidoethyl methacrylate (GAMA), from a mixed self-assembled monolayer (SAM) of an ATRP initiator-immobilized hydroxyl-terminated thiol and a methyl-terminated thiol as diluent. Fourier transform infrared spectroscopy (FT/IR-ATR). contact angle, and ellipsometry measurements were employed to confirm the grafting of the glycopolymer. The anti-nonspecific protein binding properties of this glycopolymer layer were then investigated with surface plasmon resonance (SPR). Three proteins with different size, lysozyme, bovine serum albumin (BSA), and fibrinogen were used as model solutes to investigate the influence of protein size on the protein resistance behavior. The glycopolymer chain density was controlled during surface-initiated ATRP) by varying the ratio of the components in the mixed SAM, and the chain length was adjusted by ATRP dine. The effect of chain density in combination with the protein size was also evaluated. The most important results are that poly(GAMA) layers of higher grafting density show resistance to adsorption of the model proteins used in this work and that the amount of adsorbed protein depends on the length and density of the glycopolymer chains and also on the size of the proteins.