Poly(ethylene terephthalate) (PET) nanosheets were fabricated by winding nanofibers onto a spool. The nanofibers were prepared by irradiating PET fibers with radiation from a carbon dioxide laser while drawing them at supersonic velocities. A supersonic jet was generated by blowing air into a vacuum chamber through the fiber injection orifice. A new vacuum chamber was developed to produce nanosheets; it has seven fiber injection orifices and a spool to collect the nanofibers. A rectangular nanosheet that was 17 cm wide, 18 cm long, and 30 pm thick was obtained by collecting nanofibers for 10 min. The nanosheet is composed of nanofibers with an average fiber diameter of 350 nm. This technique is a novel method for producing nanosheets. (C) 2010 Elsevier Ltd. All rights reserved.