Freeze-dried porous solid foams were prepared from carbon nanotube (CNT) suspensions via either contact freezing with a heat exchanger or immersion freezing into a cryo-bath. Microstructures in the freeze-dried foam cast by ice crystals formed during the freezing step. It was found that domains of the carbon nanotubes in the freeze-dried solid foams were fairly well interconnected, and the microstructures were largely influenced by the freezing condition and freezing method. A mathematical model was proposed to simulate the observed thermal history during the freezing step; then theoretical predictions of the microstructural features were attempted. The simulated thermal history was in good agreement with experimental result. The resulting mean ice crystal sizes L* could be estimated from the calculated freezing front velocity (R) and the temperature gradient in the frozen zone (G). Interestingly, it was found that a correlation based on the power law (L* proportional to R-0-2 G(-0.2)) was applicable to the present system for both the contact and immersion freezing methods. Though the fundamental ice crystallization phenomena were essentially the same for both freezing methods, actual temperature distribution and movement of the freezing front through the whole freezing bulk could control the morphology of ice crystal in the frozen matrix. In other words, good control of thermal flow in the freezing system would greatly contribute to rational design of microstructures of the CNT foam. (C) 2009 Elsevier Ltd. All rights reserved.