The influence of physical parameters and of flow patterns on the prediction of n-heptane ignition dynamic in transient reacting n-heptane jets, in high pressure environment under laminar conditions, has been explored by using different kinetic mechanisms. Some preliminary transient laminar flamelet computations have been performed, thus showing that the sensitivity of the ignition time to strain rate depends on the kinetic mechanism used. Therefore, the structure of the reacting jet, in particular the localization of ignition spots, is investigated. The results show that, if the initial temperature of the reacting mixture is out of the intermediate range (800-1000 K) towards lower values, the fluid dynamics has an essential role. In this case, the ignition delay time is almost insensitive to the specific kinetic mechanism adopted, conversely it is severely shortened by increasing the streamwise velocity. The burning spot is located in the core of fuel roll-up, where low values of scalar dissipation rate occur. Nevertheless, the most reactive mixture fraction conditions are well predicted by chemical kinetics, as they are in good agreement with those computed for the one-dimensional diffusion layer. When the initial temperature of fuel and air is increased in the intermediate range, ignition is strongly dependent on the kinetic mechanism used. In these cases, the choice of an accurate chemical scheme is fundamental in order to obtain reliable results. (C) 2009 The Combustion Institute. Published by Elsevier Inc. All rights reserved.