The mechanical properties and microstructure were evaluated and analyzed by optical microscopy (OM) and transmission electron microscopy (TEM) for micro-alloy carbon steel weld metal with and without Nb addition, respectively, under different heat treatment processes including stress relief annealing, normalizing, and no treatment after welding. The strength and elongation of the weld metal without treatment after welding were improved with the addition of Nb element, and the impact toughness was not affected obviously with the Nb addition. After stress relief annealing, the strength decreased for the Nb-free weld metal, while the elongation and impact toughness increased. However, for the Nb-bearing weld metal, stress relief annealing improved the strength of the weld metal significantly, and deteriorated the elongation and impact toughness. In the case of normalizing treatment to the weld metal, it was shown that with the increase of the holding time at the normalizing temperature of 920 A degrees C, for both the weld metals with and without Nb addition, the microstructure of the columnar grain zone (CGZ) was transformed from one of columnar grain into one of equiaxed grain. The grain size of the equiaxed grain zone (EGZ) increased initially, then remained almost unchanged with the prolonging of the holding time. The mechanical properties of the weld metal with and without Nb addition showed no obvious change with the increasing holding time. With the increase of the normalizing temperature, the strength of the Nb-bearing weld metal increased, while the elongation and impact toughness decreased significantly. OM and TEM analysis found that the fine NbC particles were precipitated at the normalizing temperature of 920 A degrees C, which refined the grains of the weld metal and increased the impact toughness. With the increase of the normalizing temperature, the content of widmanstatten ferrite (WF) in the Nb-bearing weld metal increased, whereas the quantity of the NbC particles decreased, which improved the strength and lowered the impact toughness.