The results of a wet alkaline seed deposition process directly on a thin adhesion promoter film, such as chemical vapor deposition (CVD) Co, are presented. This solution has been successfully used for copper plating on blanket and patterned through-silicon-via (TSVs) wafers covered with either silicon oxide/physical vapor deposition (PVD) Ta/CVD Co or silicon oxide/PVD Ti/CVD Co stacks. Such direct plated films were used as seed layers for subsequent copper plating from an in-house-made acidic Cu bath with model additives poly (ethylene glycol) (PEG), bis (3-sulfopropyl) disulfide (SPS), and Janus Green B (JGB). We report the impact of the directly plated stack composition and thicknesses on the integration of the wet alkaline seed in TSVs with 5 mu m width and high aspect ratio (HAR) as high as 8:1. The conformal wet seed layer enables the achievement of a successful void-free filling using an in-house made acidic Cu bath with model additives (SPS, PEG, and JGB). (C) 2010 The Electrochemical Society. [DOI: 10.1149/1.3518439] All rights reserved.