Temperature responsive or bactericidal coatings with poly(n-butyl methacrylate) (PBMA) as bulk material and surface segregated poly(n-butyl acrylate)-block-poly-(N-isopropylacrylamide) (PBA-b-PNI-PAAm) or poly(n-butyl acrylate)-block-quaternized poly(2-(dimethylamino)ethyl methacrylate) (PBA-b-PDMAEMAq) as additive were prepared via sequential solvent evaporation of polymer solutions in a solvent mixture. The degree of enrichment at the air surface of the coating and the functionality were examined for different molecular weight additives with different block ratios obtained via Atom Transfer Radical Polymerization (ATRP). The design of the block copolymers with an anchor block (PBA) which is compatible with the bulk polymer (PBMA) and water-compatible functional blocks (PNIPAAm and PDMAEMAq) along with the selection of suited solvent mixtures based on pre-estimation of the selective solubility and sequential evaporation via the Hansen solubility parameters and vapor pressures, respectively, were found to work very well. A small fraction of water in the solvent mixture had been crucial to obtain surface segregation of the functional block, e.g., a PNIPAAm surface with temperature-switchable wettability. Reversible temperature dependent wettability and long term stability of the functionalization, based on contact angle data, were obtained for an optimized PBA-b-PNIPAAm additive. Surface charge density, estimated from dye binding and zeta potential measurements, and killing efficiency against Staphylococcus aureus were investigated for PBA-b-PDMAEMAq as additive. Both block copolymer additives were found to dominate the surface properties and the functionality of the PBMA coating. (C) 2010 Elsevier Ltd. All rights reserved.