Polymer polymer composites comprised of vinyl ester matrices (VE) and polypropylene (PP) fiber meshes were fabricated and tested in this investigation. Results indicated that PP fibers greatly enhanced fracture toughness; however, strength of the VE was significantly reduced as voids were observed at the interface of the PP and VE. A two-step surface modification, oxygen plasma treatment followed by grafting vinyltrimethoxysilane (VTMS), was conducted on PP fibers in an effort to improve interfacial strength. Interfacial discontinuities of composites were improved after surface modification of PP. The oxygen plasma treatment added hydrophilic functional groups but caused surface roughness. Surface treatment of PP slightly increased fracture toughness of the PP-VE composite by enhancing energy absorption capacity at the interface. However, mechanical strength and modulus did not significantly increase for the composite using VTMS grafted PP fibers due to the weak fiber material. Small PP fibers with higher strength may attain the expected improvement in mechanical properties after surface treatment. (C) 2010 Elsevier Ltd. All rights reserved.