Surface texturing (for example, producing micro dimples on the surface) of mechanical parts has a great potential to improve the surface tribological properties. Surface texturing through nanosecond laser ablation has many associated advantages and hence has drawn lots of attentions. However, the produced micro dimple bottom (if through laser spot scanning) is often very rough, which may harm the surface tribological properties. In this paper, a two-step laser surface texturing process is proposed and studied, where a relatively high-fluence laser ablation step (which is to create dimples) is followed by a low-fluence laser-induced melting, melted material flow and re-solidification step (which is to smooth the ablated dimple bottom surface). The study shows that the two-step laser surface texturing process can produce dimples with very smooth bottom surfaces. The effects of laser pulse duration and scan speed in Step 2 on the dimple bottom surface morphology and roughness have also been investigated, and some very interesting physical phenomena have been found, which have been rarely reported before in literature. Some hypothesized explanations are given for the observed effects, which require future work to completely understand their underlying mechanisms. (C) 2011 Elsevier B.V. All rights reserved.