Significant deviations between published results have been reported measuring the effective thermal conductivity of nanofluids with the transient hot-wire method (THWM). This may be attributed to a poor selection of the temperature data range, which should meet the following conditions. The start time should be chosen after the conductive heat flux delay time, while the end time should be selected before a crossover point when natural convection becomes significant. Considering an EG-based 1.06 vol.% ZnO nanofluid, the thermal conductivity was measured to increase by 5.4% over that of the base fluid. (C) 2011 Elsevier Ltd. All rights reserved.