Composites based on poly(vinyl alcohol) (PVA), acrylamide monomer (AM) and sodium montmorillonite clay (MMT) were prepared, in the form of thin films, by solution casting. The PVA/AM/MMT composites films were then exposed to electron beam irradiation to form crosslinked network structure. The structure-property behavior of PVA/AM/MMT hybrids was demonstrated by x-ray diffraction (XRD), scanning electron microscopy, gel content, color intensity, thermogravimetric analysis (TGA) and swelling behavior in aqueous solutions. The results indicated that the introduction of MMT clay ratio up to 5% decreased the gel content of PVA/AM hydrogels. The color measurements indicated that the introduction of MMT clay ratio up to 5% was shown to affect the color intensity of composite films. It was found that both PVA/AM hydrogels and PVA/AM/MMT composites reached the equilibrium swelling state in water after four hours; however PVA/AM/MMT composites displayed higher swelling than PVA/AM hydrogels. However, the swelling of PVA/AM hydrogels or their composites at the equilibrium state increased with increasing temperature up to 60 degrees C. (C) 2011 Wiley Periodicals, Inc. J Appl Polym Sci 121: 2634-2643, 2011