The development of natural adhesives derived from nonfossil resources is very important for the future. Besides, it is desirable to be safe adhesives without using harmful chemical substances. In this study, application of citric acid as a natural adhesive was investigated. Citric acid powder and bark powder obtained from Acacia mangium were used as raw materials. Citric acid powder was mixed with the bark powder, and the resulting powder mixture was poured into a metal mold. The mold was hot-pressed at 180 degrees C and 4 MPa for 10 min, and a bark molding was then obtained. The specific modulus of rupture and modulus of elasticity values of the molding containing 20 wt % citric acid were 18.1 MPa and 4.9 GPa, respectively. The molding did not decompose during a repeated boiling treatment. To clarify the effect of tannin on the adhesiveness of molding, bark was separated into tannin and residue. The molding was not obtained while using the tannin due to the marked fluidity, whereas it was obtained while using the residue, the same as while using the bark. It was considered that components other than tannin contributed to the adhesiveness. Based on the results of Fourier transform infrared spectra, the formation of ester linkages between carboxyl groups derived from citric acid and hydroxyl groups in the bark was confirmed. Accordingly, citric acid brought an adhesion by chemical bonding, and it could be used as a safe natural adhesive. (C) 2011 Wiley Periodicals, Inc. J Appl Polym Sci 123: 1991-1996, 2012