A new approach for estimating chemical emissions from wet products has been developed. The concept of such approach is that emission rates can be estimated from the amount of target chemicals in the product as a function of evaporation time. Samples were placed under a laboratory fume hood under controlled conditions (surface air velocity and temperature). Weight losses of the product were monitored and residuals at different time intervals were chemically analyzed. Emission factors of the target chemicals were then calculated based on the weight losses and residual levels of the chemicals. To demonstrate the applicability of this approach, two wet products with very different physical characteristics, one liquid and one paste-like viscous fluid, were chosen. Emissions of two principle chemicals in the products, decamethylcyclopentasiloxane (D5), and dodecamethylcyclohexasiloxane (D6) were measured. The influences of initial sample weight, surface air velocity, and temperature were investigated. The calculated emission profiles were compared with those obtained from the chamber method. The described approach could be used as an alternative screening method for emission tests of wet products, especially for compounds with low vapour pressure when sink effect poses serious challenge in traditional chamber-based emission tests. Crown Copyright (C) 2011 Published by Elsevier B.V. All rights reserved.